| When you
use aluminum capacitors remember the following: |
 |
Polarity |
| |
Aluminum
Electrolytic Capacitors are polarity, do not apply reverse
voltage or AC voltage.
Please use non-polarized capacitors for a circuit that
can possibly see reversed polarity. |
|
| |
|
Operating
voltage
|
| |
Do
not apply excess voltage continuously when over voltage
is applied to the capacitor
Leakage current increase drastically. Applied working
voltage to capacitors should not exceed the rated working
voltage of capacitor. |
|
| |
|
Ripple
current
|
| |
Do
not apply a ripple current exceeding the rated maximum
ripple current.
The capacitor should be applied within specified allowable
ripple current value in table if
the capacitor needs high ripple current exceed specified
value please consult us for your
high ripple purpose. |
|
| |
|
For
charge and discharge circuit |
| |
The
electrolytic capacitor is not suitable for sudden charge
and discharge which occurs
frequently causing damage by Internal healing. Please
consult us your application if you
have sepcial purpose. |
|
| |
|
Operating
stored and temperature
|
| |
The
capacitor should not be used at any temperature exceeding
the rang of specified in
each products. When the capacitors are stored for along
time, it must not be left under
high temperature and high humid. Place to avoid its deteriorations
of electrical
characteristice and solderable of lead wire. |
|
| |
|
Soldering |
| |
Soldering
irons should be kept away from the vinyl insulated sleeves
of capacitors.
When the capacitor dipped in solder bath, recom-mendable
within 260°C and 10 seconds to avoid damage of capacitor. |
|
| |
|
Terminal
and leading wire
|
| |
Do
not apply excessive force to capacitor leads and terminals.
The excessive force may damage to leads and terminals
of capacitor units. |
|
| |
|
Sleeve
material
|
| |
The
standard sleeve material is polyvinyl-chloride if exposed
to xylene, toluene, etc, and
then subjected to high heat, the sleeve may crack. This
sleeve is not insulating material. |
|
| |
|
Vent
|
| |
It
is recommended at least 3mm of space around the vent.
If such space is not provided, the vent will not operate
completely. |
|
| |
|
Fuhjyyu Products
meet or exceed quality standards, specified by JIS-C-514W
and with the reliability requirements refer to JIS-C-5102'. |
| |
|
